「戒指卡住了怎麼辦？牙線輕鬆解決！」- How to Remove a Ring that is Stuck on your Finger DIY

Welcome to Urban How to Do. Today I'll show you how to remove a ring that is stuck using dental floss and a safety pin.
歡迎收看Urban How to Do。今天我會示範給你看，如何用牙線和安全別針來拔掉卡住的戒指。

Take about 2.5 feet of floss. Line up the floss along side of the ring. Using a safety pin, push the floss under and through the underside of the ring. Be careful not to poke yourself.
拿大約2.5英呎(約76公分)的牙線。沿著戒指的一邊排列。使用安全別針，將牙線推進穿過戒指的下側。小心別戳到你自己。

Once you see the floss, pull the floss through so that you have about six inches on the wrist side and two feet on the finger side. Hold the six-inch side under your thumb to keep it in place. Wrap the first couple of wraps close to the ring.
當你看到牙線，將牙線拉出，如此一來你在手腕側會有大約6英吋(約15公分)，並在指頭側有2英呎(約60公分)。抓住6英吋那一側置於你的拇指下固定。將一開始幾個圈往靠近戒指處繞。

The more stuck the ring, the more wraps and the closer the wraps are together, the better. Using a little bit of soap will also help.
戒指卡得越緊，繞的圈數就要越多、圈與圈越緊密排在一起越好。使用一點點肥皂也有所幫助。

Wind the floss tight. At the end of the floss, create a loop and tuck the end under the loop to secure it. Grab the six-inch end and pull it towards the finger tip. And slowly unwind the floss. You'll see the ring slowly walk down the finger and eventually slide off.
將牙線繞緊。在牙線的尾端，繞出一個環並將尾端塞到環下固定。抓住6英吋的那端，並朝向指尖拉。慢慢地解開牙線。你會看到戒指緩慢地沿著手指移動，最後滑落。

Thank you for watching this Urban How to Do video.
感謝您收看這支Urban How to Do影片。